Back Panel
1
2
4
pg.
5
The Back panel of your unit introduce
several options for a convince use and more.
The Dry line out jack (35) is your output jack
for a built in A/B box. You can use that line
out for several applications. The most
common one could be your Tuner out. That
way you can tune your instrument with a kill
switch for a quite tuning.
Another use for the Dry Line out jack (35) is
if you have another board that you like to use
as well, instead of running it all in series, you
can send your instrument through the Line
out jack (35) to the other board or effects and
bypass the entire "Steel Dream" with just one
click. Or even if you want your instrument to
be completely dry with another amp or
channel 2 of your amp, with just one click
you can bypass the entire board and direct
your instrument to that position.
Fuse (34 spare), (33).
Your unit is protected with a fuse in the event
of wrong power supply used with the unit
other than specified. In the event the fuse is
blown in a middle of a show you have a
spare one for an immediate use. All you have
to do is pop out the spare socket and put it in
the slot of the blown fuse and you're good to
go.
Your unit come with dual In/Out 9V DC jacks.
They are parallel and either one of them can
be used. The benefit of having a second one
is that your unit can power other pedals if
added to the chain using the second 9V DC
jack. All you'll need is a daisy chain.
NOTE: Make sure you know the max mA
that you're power supply can handle
.
3
The Steel Dream pedal board come with
effect loop option. There are several ways
you can use this option and I will show you a
few of them on the diagram page.
Here are some common uses for the loop
option:
If your amp does have an effect loop you can
send the delay and reverb of the steel dream
to the loop and your Nutradrive to the front of
the amp. This is by far the best tone.
This is how you do that.
Plug your instrument to the input of the board
(1) and send out to your amp input using
either output 1 or 2 (28) (27).
Using the send/out (29) jack on your board to
the receive of your amp (loop) and send of
your amp to the In/receive (30) of your
board. Make sure the loop switch (19)
positioned on your echo zen pedal is set to
On.
Now your delay and Verb are running
through the loop of the amp and the
Nutradrive comes to the front of the amp.
Benado effects
