RCMS460-490_D00067_00_Q_XXDE / 03.2021 5
LINETRAXX® RCMS460-D/-L, RCMS490-D/-L
Inbetriebnahme
1. Versorgungsspannung aller am BMS-Bus ange-
schlossenen Geräte zuschalten. Am RCMS… blinkt
zunächst die LED „ON“ und das Grafikdisplay des
RCMS…-D… zeigt das Startbild (Bender) an.
Anschließend leuchtet die LED „ON“ dauerhaft.
2. BMS-Busadressen einstellen.
3. Keine Adressen doppelt vergeben.
4. Prüfen: Adresse 001 (Masterfunktion) vergeben?
5. Landessprache auswählen
6. Messstromwandlertyp für jeden Kanal einstellen
7. PRESET-Funktion ausführen (Menü 6.2)
8. Nicht belegte Messkanäle abschalten, um
Gerätefehler zu vermeiden
9. Isolationsfehler und Fehlermeldungen beseitigen.
Menü-Übersicht
Commissioning
1. Connect the supply voltage of all devices connec-
ted to the BMS bus. Initially, the „ON“ LED flashes
on the RCMS… and the RCMS460…-D graphic dis-
play shows the (Bender) welcome screen. The
„ON“ LED then lights up permanently.
2. Set the BMS bus addresses.
3. Never assign one address twice.
4. Check, if address 001 (master function) has been
assigned
5. Select the language
6. Set the CT type for each channel
7. Start the PRESET function
8. Switch off unassigned measuring channels to avo-
id device errors
9. Eliminate insulation faults and the associated fault
messages
Menu overview
Zurück
1. Alarm/Messwerte
2. % Balkenanzeige
3. Historie
4. Harmonische
5. Datenlogger
6. Einstellungen
7. Steuerung
8. Externe Geräte
9. Info
Zurück
Zurück
6.1. Allgemein
6.2. PRESET
6.3. Kanal
6.4. Relais
6.5. Historie
6.6. Datenlogger
6.7. Sprache
6.8. Schnittstelle
6.9. Alarmadressen
6.10. Uhr
6.11. Passwort
6.12. Werkseinstellung
6.13. Service
Zurück
Zurück
7.1. TEST
7.2. RESET
7.3. Test Kommunikation
Exit
6.1. General
6.2. PRESET
6.3. Channel
6.4. Relay
6.5. History
6.6. Data logger
6.7. Language
6.8. Interface
6.9. Alarm addresses
6.10. Clock
6.11. Password
6.12. Factory setting
6.13. Service
Exit
Exit
7.1. TEST
7.2. RESET
7.3. Test communication
1. Alarm/meas.values
2.% Bar graph
3. History
4. Harmonics
5. Data logger
6. Settings
Exit
7. Control
8. External devices
9. Info
Exit