89000109-002
xVue Touch Installation Manual
Rev 2
Page 6-15
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
Figure 6-19 Pilot V-Spd Locked/Unlocked Toggle
6.2.1.7 Engine Configuration
The Engine configuration is accessed from the System Config sub-menu, Figure 6-8, refer to Section 6.2
and the current Engine configuration selection is shown on the Engine button.
(1) Press the Engine button to toggle from Single to Multi, shown in Figure 6-20.
Figure 6-20 Engine Configuration
(2) Press the Back-Arrow button to exit the System Config sub-menu and return to the Installer Main
Menu, Figure 6-7.
6.2.1.8 Units Configuration
The Units configuration is accessed from the System Config sub-menu, Figure 6-8, refer to Section 6.2 and
the current Unit configuration selection is shown on the Units button.
(1) Press the Units button to toggle between Knots (KT) and Miles per Hour (MPH), shown in Figure 6-
21.
Figure 6-21 Units Configuration
NOTE
THE DEFAULT SELECTION IS SINGLE ENGINE. WHEN THE INDICATOR SHOWS MULTI, THE
KSD 100EXP WILL DISPLAY ADDITIONAL V-SPEED PARAMETERS: MINIMUM CONTROL
SPEED (V
MC
) AND BEST RATE OF CLIMB SPEED (V
YSE
).
NOTE
THE DEFAULT UNIT SELECTION IS KNOTS (KT). THE UNITS USED ON THE KSD 100EXP MUST
BE SET TO THE SAME UNITS PUBLISHED IN THE AIRPLANE FLIGHT MANUAL (AFM).
