89000109-002
xVue Touch Installation Manual
Rev 2
Page 6-40
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
orientation is changed, the CMT application will display dashes for the actual Pitch and Roll Offsets and
actual Pitch and Roll Angles.
When the orientation of the KG 71EXP is properly selected, the installation offsets must then be
determined. The technician will click the
Detect Offsets
button. The KG 71EXP will analyze the data using
the new orientation to determine the actual offsets. Note, the re-calculation of offsets may take several
seconds.
Figure 6-48 KG 71EXP Orientation Drop-Down List
Once the new offsets using the new orientation are determined, the pitch angle and roll angle are
measured and displayed.
If the KG 71EXP pitch and roll offsets are installed within ±15 degrees and the detected pitch and roll
angle are within ±1 degree (typically, the actual pitch and roll should be less than ±0.5 degree), then
detection of offsets was successfully done. If displayed values are within the ranges specified above, the
technician should press the
Save Orientation and Offsets
button. The offsets and orientation will be
stored into the KG 71EXP memory and the confirmation screen will be displayed as illustrated in Figure 6-
49.
If the pitch and roll offsets or the actual pitch and roll angles are not within range then the KG 71EXP’s
physical positioning must be adjusted to reduce the offsets and the KG 71EXP orientation calibration
procedure then repeated.
NOTE
IF THE DEFAULT ORIENTATION WAS NOT CHANGED, THE OFFSETS DETECTION CAN STILL
BE PERFORMED VIA
DETECT OFFSETS
BUTTON.
