89000109-002
xVue Touch Installation Manual
Rev 2
Page 7-13
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
(6) Synchronize the course to the VOR bearing to station value by pushing and holding the CRS knob
on the KCP 100EXP Control Panel.
(7) Place the Autopilot in Navigation mode, with the autopilot engaged; use the ramp generator or
change the course to simulate both left and right deflections.
(8) Validate the autopilot commands respond correctly in both directions.
(9) Place the Autopilot in Approach mode and using a ramp generator to simulate a valid localizer and
glide slope signal.
(10) With the autopilot engaged, use the ramp generator to simulate both up and down glide slope
deflections.
(11) Validate the autopilot commands respond correctly in both directions.
7.2.11 KCP 100EXP Checkout
Perform an interface test of the KCP 100EXP control panel by performing to following procedure:
(1) Turn the heading knob to the left and verify heading value decreases.
(2) Turn the heading knob to the right and verify heading value increases.
(3) Verify the heading on the HSI to the current detected heading by pushing the HDG knob on the
KCP 100EXP.
(4) With no Flight Plan on the Navigator and VLOC selected,
(a) Turn the course knob to the left and verify course value decreases.
(b) Turn the course knob to the right and verify course value increases.
(5) Enter a Flight Plan to an OBS WPT on the Navigator
(a) Verify the course on the HSI is synchronized with the GPS Bearing to WPT value by pushing
the CRS knob on the KCP 100EXP.
(6) Turn the baro knob to the left and verify baro value decreases.
(7) Turn the baro knob to the right and verify baro value increases.
(8) Verify the baro is set to the standard 29.92 inHg/1013 hPa by pushing the Baro knob on the KCP
100EXP.
(9) Turn the altitude outer knob to the left and verify altitude value decreases by 1000 increments.
(10) Turn the altitude outer knob to the right and verify altitude value increases by 1000 increments.
(11) Turn the altitude inner knob to the left and verify altitude value decreases by 100 increments.
(12) Turn the altitude inner knob to the right and verify altitude value increases by 100 increments.
(13) Verify the selected altitude is synchronized to the current altitude value by pushing the Alt knob
on the KCP 100EXP.
7.2.12 Interfaced Subsystem Checkout
7.2.12.1 Navigator
After wiring KG 71EXP heading and air data inputs to the KSN 7XX, verify that TAS Fail message and HGD
Fail messages are not present. For Garmin or Avidyne navigators, refer to the devices’ install manual for
proper configuration and checkout for these inputs.
7.2.12.2 TAWS/Traffic
Refer to KMH install manual for diagnostic tool to verify air data and heading inputs.
7.2.13 Lighting Checkout
Evaluate the dimming of the KSD 100EXP Display and KCP 100EXP Legends and Rings throughout the
range and adjust the brightness levels as described in Section 6.2.1.2 External Dimming to match the
