89000109-002
xVue Touch Installation Manual
Rev 2
Page 9-5
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
KSD 100EXP PFD
A general visual inspection of the KSD
100EXP PFD and the associated wiring must
be performed during each annual
inspection. Visually check wiring for general
condition, routing, chafing, bonding straps
and/or wires and integrity of clamping and
stand-offs. Visually check the mechanical
installation for condition, including
checking the unit and all mounting brackets
for security.
Loose and chafing brackets will increase the
resistance between parts. Check for signs
that the units have not been tampered with
or removed. Inspect and verify the bonding
straps or ground wires are in good
condition, and are not loose or chafing.
Connection points to the units and to the
airframe must be inspected for evidence of
corrosion.
If any of these indications are present, an
electrical bonding test must be performed.
12 months
KMG 7010/MD32
Magnetometer
A general visual inspection of the KMG
7010/MD32 Magnetometer and the
associated wiring must be performed
during each annual inspection. Visually
check wiring for general condition, routing,
chafing, bonding straps and/or wires and
integrity of clamping and stand-offs.
Visually check the mechanical installation
for condition, including checking the unit
and all mounting brackets for security.
Loose and chafing brackets will increase the
resistance between parts. Check for signs
that the units have not been tampered with
or removed. Inspect and verify the bonding
straps or ground wires are in good
condition, and are not loose or chafing.
Connection points to the units and to the
airframe must be inspected for evidence of
corrosion.
If any of these indications are present, an
electrical bonding test must be performed.
12 months
Table 9-1 ICA Inspection Criteria
xVue Touch System
Component Description
Inspection Requirement
Recommended Minimum
Inspection Interval
Completed
