9
Fig. 3.1
STEP 3
(Adjusting Lift / Jack Orientation)
1. Following the manufacturer’s instructions in the lift
manual. Lower the lift to the ground. (If using a shop crane,
you may need to lock the lift on the
fi
rst Safety Lock to
make room for the legs of the Shop Crane.)
2. If adjustable, adjust the Runway of the lift to the
desired width. Be sure to check the speci
fi
cations of the
lift and the Rolling Bridge Jacks to be sure that the Rolling
Bridge Jack can be adjusted to the desired Runway width.
(See Fig. 3.1 & 3.2)
Summary of Contents for RJ-12
Page 2: ...2 This page intentionally left blank...
Page 10: ...10 Fig 3 2...
Page 16: ...16...
Page 20: ...20...
