18
STEP 11
(Installing power unit hose assembly
and Power Side safety cover)
1. After safeties have been adjusted and checked for
proper operation, install and tighten Power Side safety
cover and Off Side safety cover mounting screws.
(See Fig. 11.1)
2. Install the floor plate between the columns as shown.
For Wide configuration use the floor plate extension.
(See Fig. 11.2)
STEP 12
(Installing the Lift Arms)
1.
Place the appropriate lift arm assembly in the lift
heads. (See Fig. 12.7)
2. Install the lift head pins into the lift head and through
the holes in the arm assembly. (See Fig. 12.1)
3. Install the snap ring into the groove in the lift head pin
on under side of the lift head. (See Fig. 12.2)
4. Each arm restraint gear can be oriented in a Left
or Right confi guration on the arms. Each arm and arm
restraint gear must be positioned in the proper location in
the lift head. (See Fig. 12.3 - 12.4)
Fig. 11.1
Screw
Floorplate
Floorplate
Extension
Fig. 11.2
Fig. 12.1
Lift Head
Pin
Lift Head
Pin
Snap
Ring
Snap
Ring
Lift Head
Fig. 12.2
Lift Head
Pin
Lift Head
Pin
Snap
Ring
Snap
Ring
NOTE:
LEFT AND RIGHT ARE DETERMINED WHEN FACING
THE INSIDE. OPEN SIDE OF THE LIFT POST.
DANGER!
THE ARM RESTRAINT GEARS MUST BE
POSITIONED AND ADJUSTED PROPERLY.
CONFIRMATION OF PROPER GEAR ENGAGEMENT
MUST BE MADE PRIOR TO THE OPERATION OF THE
LIFT. PERIODIC INSPECTION AND ADJUSTMENT
IS REQUIRED. FAILURE TO INSPECT AND ADJUST
THE ARM RESTRAINT GEARS ON ALL FOUR ARMS
PROPERLY CAN RESULT IN DAMAGE TO THE
VEHICLE OR INJURY AND/OR DEATH.
Fig. 12.3
NOTE: Arm gears rings have
Left and Right orientations
