5
INSTALLER / OPERATOR
PLEASE READ AND FULLY
UNDERSTAND. BY PROCEEDING
YOU AGREE TO THE FOLLOWING.
I have visually inspected the site where the lift is to
be installed and verifi ed the concrete to be in good condi-
tion and free of cracks or other defects. I understand that
installing a lift on cracked or defective concrete could
cause lift failure resulting in personal injury or death.
I understand that a level fl oor is required for proper
installation and level lifting.
I understand that I am responsible if my fl oor is of
questionable slope and that I will be responsible for all
charges related to pouring a new level concrete slab if
required and any charges.
I understand that BendPak lifts are supplied with
concrete fasteners meeting the criteria of the American
National Standard “Automotive Lifts - Safety Requirements
for Construction, Testing, and Validation” ANSI/ALI
ALCTV-2006, and that I will be responsible for all charges
related to any special, regional, structural, and/or seismic
anchoring requirements specifi ed by any other agencies
and/or codes such as the Uniform Building Code (UBC)
and/or International Building Code (IBC).
I will assume full responsibility for the concrete fl oor
and condition thereof, now or later, where the above
equipment model is to be installed. Failure to follow
Danger, Warning, and Caution instructions may lead to
serious personal injury or death to operator or bystander
or damage to property.
I understand that BendPak lifts are designed to be
installed in indoor locations only. Failure to follow instal-
lation instructions may lead to serious personal injury or
death to operator or bystander or damage
to property or
lift.
Failure to follow Danger, Warning, and Caution instruc-
tions may lead to serious personal injury or death to
operator or bystander or damage to property.
Please read the entire manual prior to installation.
Do not operate this machine until you have read and
have understood all of the Danger, Warning and Caution
alerts in this manual. For additional copies
or further information, contact:
BendPak Inc.
1645 Lemonwood Dr.
Santa Paula, CA. 93060
1-805-933-9970
www.bendpak.com
INSTALLER / OPERATOR
PROTECTIVE EQUIPMENT
Personal protective equipment helps makes installation
and operation safer, however, it does not take the place
of safe operating practices. Always wear durable work
clothing during any installation and/or service activity.
Shop aprons or shop coats may also be worn, however
loose-fi tting clothing should be avoided.
Tight-fi tting leather gloves are recommended to protect
the technician’s hands when handling parts. Sturdy leath-
er steel-toe work shoes and oil resistant soles should be
used by all service personnel to help prevent injury during
typical installation and operation activities.
Eye protection is essential during installa-
tion and operation activities. Safety glass-
es with side shields, goggles, or face
shields are acceptable. Back belts provide
support during lifting activities and are
also helpful in providing worker protection.
Consideration should also be given to the use of hearing
protection if service activity is performed in an enclosed
area, or if noise levels are high.
THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH IF NOT FOLLOWED
COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OR YOURSELF AND OTHERS
AND CAN CAUSE PERSONAL INJURY OR DEATH. READ AND FOLLOW ALL INSTRUCTIONS IN
THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
