- 130 -
CHAS
Lubricate:
•
The bearings Fig. A.
•
The dust seal rings Fig. A.
•
The bearing tracks Fig. A.
NOTE
Use special grease.
Fit:
•
The steering ring nut with the special tool at the following
torque:
T.R.
Torque 16 N*m
(**) Tool to tighten the steering sleeve lock nut
Code:......................
IMPORTANT NOTICE
Do not overtighten the steering ring nut.
•
The steering ring nut support with the special tool to the
following torque:
T.R.
Torque 60 N*m
Fit:
•
The front fork stems as described previously.
Fit:
•
The cap (4) Fig. B with the special tool to the following
torque:
T.R.
Torque 60 N*m
(**) steering head wrench
Code:......................
•
The screws (3) securing the top steering column Fig. B to
the following torque:
T.R.
Torque 22 N*m
Check:
•
The steering sleeve Fig. C.
Gently oscillate the front fork, holding it by the ends of the tubes.
If there is any jamming/loosening, adjust the steering sleeve.
STEERING HEAD
TOP AND BOTTOM STEERING BASE FITTING
A
B
4
3
3
C
Summary of Contents for 2014 BN600
