- 156 -
CHAS
EXHAUST
EXHAUST INSTALLATION
Assemble:
•
The silencer (8) with the bracket (14) Fig. D
•
Apply thread locker to the screws (11) and tighten to the
following torque:
T.R.
Torque 13 N*m
Fit:
•
The two rubber tips (A) to the rear frame Fig. E
•
Insert the pins (B) of the silencer (8) inside the rubber tips.
•
Put in the fastening screws (12) and the relevant nuts (16)
Fig. E
Assemble:
•
The exhaust manifold fi tting (7), inserting it between the
silencer and the exhaust manifold, so that the two graphite
gaskets (4) are aligned Fig. F.
Tighten:
•
The nuts (2) previously screwed onto the engine block studs
to the following torque:
T.R.
Torque 20 N*m
Tighten:
•
The clips (20) to the respective manifolds and lastly, the
screw (6) to the bracket (B) Fig. G.
D
E
F
G
8
14
A
B
12
4
4
6
B
EXHAUST ASSEMBLY REMOVAL
Removal:
•
carry out the installation steps in reverse order.
Summary of Contents for 2014 BN600
