- 216 -
ENG
GEAR ASSEMBLY
GEAR ASSEMBLY
Assembly
After assembling the two half casings, tighten the relevant
screws Fig.Q to the following torque:
Outer screws (xx) and (ZZ)
Inner screws (yy)
T.R.
M6 X40: Torque 22 N*m
M6X60: Torque 22 N*m
M10: Torque 39 N*m
NOTE
Before securing the screws, they must be greased with copper
grease.
Turn the full casing by 180° and tighten the respective screws
Fig. R, to the following torque:
NOTE
Before securing the screws, they must be greased with copper
grease.
Q
yy
yy
XX
ZZ
XX
R
XX
GEAR DISASSEMBLY
Disassembly:
To disassemble, follow the assembly procedure in the previous
section, in reverse order.
Check:
Make sure that the end of the gear retainer spring (3) does not
come away from the selector plate (1) and that when idle, the
two ends of the spring and strike pin is “0”, Fig. O.
Measure:
•
the size of the spring Fig.P.
If there is any warping or weakening, replace.
Gear stop spring
Size
A
14.5 mm
B
8 mm
Assembly
Insert the selector shaft as in Fig. O
O
3
1
“0”
P
Summary of Contents for 2014 BN600
