4 - 25
NOTE:_________________________________
Drain out the brake fl uid before proceeding with these oper-
ations.
Refer to Chapter 3: Periodic maintenance, paragraph “Check-
ing and topping up the front brake fl uid level”.
IMPORTANT NOTICE
When removing the pump, avoid spilling onto the surfaces of
the motorcycle brake fl uid that has remained in the system.
Remove:
•
the special screws (22*)
•
sealing washer (9*).
•
Remove the front brake hose (10*).
•
Detach the front brake hose (10*).
•
disconnect the connector of the front brake switch (1) Fig. A.
• screw
(27*)
• micro-switch
(28*).
• nut
(26*)
• screw
(23*)
•
front brake lever (25*)
• screws
(21*)
• clamp
(2*).
•
remove the pump.
IMPORTANT NOTICE
during the disassembly stage, do not allow any brake fl uid
remaining in the circuit to drip onto the vehicle.
NOTE:_________________________________
The numbers marked (*) are a part of the table at the begin-
ning of the chapter.
A
1
FRONT AND REAR BRAKES
FRONT BRAKE PUMP REMOVAL
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk
Summary of Contents for TRK 502
