1 - 8
IMPORTANT INFORMATION
SAFETY SNAP RINGS
Before reassemble them, check all snap rings thoroughly and
replace the damaged/deformed ones.
Always replace the snap rings of the piston pin after having used
them once. When installing a snap ring “A”, make sure the sharp
edge “B” is positioned on the other side compared to the thrust
“C” that it receives.
Shaft “D”
CHECKING CONNECTIONS
Make sure there are no stains, rust, humidity, etc. on wires,
couplers, and connectors.
1. Disconnect:
• the
wire
• the
coupler
• the
connector
2. Check:
• the
wire
• the
coupler
• the
connector
In presence of humidity
→
Dry using a fan.
In presence of rust/stains
→
Connect and disconnect the parts
several times.
3. Check:
• all
connections
In case of loose connections
→
Connect them properly.
NOTE:_________________________________
If the foot of the terminal “A” is bent, raise it.
A
B
C
D
A
1
2
3
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk
Summary of Contents for TRK 502
