3. Setting the delta-temperature and maximum water temperature
On delivery, your Benisol is pré-installed. The maximum pool temperature can be installed,
this will be pré-set on 32 °C. Also the delta temperature can be set. This is the difference in
temperature between the pool and the EPDM panels and is pré-set on 4°C. If you want to
personalise the maximum and delta temperatures you can do so by following these steps
.
Choose the maximum temperature difference between the outer air and the water (Yellow
circle). Usually a difference of 4 degrees is chosen. In the example photograph below : when
the outer air is more than 4°C warmer than the water, the automatic valve (or pump) will be
activated and the will send pool water through the heating system.
To set the maximum pool water temperature, it is necessary to make sure the switch in the
blue circle (left top) to position 1.
The maximum water temperature is then set on the bottom switches (blue circle)
Usually a max temperature of 32 degrees is chosen. In the example photograph below :
when the pool water temperature is more than 32°C , the automatic valve (or pump) will be
deactivated and the will Not send water through the heating system
Figure 3
