Heating and Hot Water
The heating and hot water within the
Benimar Sport 310 is powered by plugging
in to the mains via the electric hook up
cable supplied or off the gas which has
also been supplied. The control panel for
the heating and hot water is situated on
the side of the rear facing seat in the
motorhome. The left hand dial selects the
hot water and the right hand dial controls the heating.
For hot water, Press top of the switch for 50’c or press the bottom of the switch for 70’c.
For heating press the top left button, and rotate the dial to control the required
temperature.
Top left button will turn the heating on,
Middle button will turn the heating off,
Bottom left will turn of the cool air blower on,
Ensure that the control panel above the main caravan door is turned on; check that the
water pump is on; check the gas is turned on; connect the hook-up cable if possible and
that there is sufficient water in the system.
Fault finding (red light showing on temperature dial)
Gas bottle empty – Change bottle
Hook-up not connected correctly – check display
No water in system – fill with water
Water pump not switched on – switch on
Main control panel not turned on – turn on the power
Air in system. Turn dial on and off 2 or 3 times until green or amber light shows. Leave of
for 15 seconds.
Toilet Cassette
To empty toilet cassette, ensure the toilet waste release is in the closed position (handle
at the side of the toilet basin), open the external toilet door and remove the cassette by
lifting the bottom yellow flap and pull the cassette towards you. Extend end tube and
unscrew yellow cap. Whilst depressing small round breather inlet pour waste into
designated area and rinse cassette out with fresh water. Pour about 50 ml of toilet
chemical and 2 litres of fresh water in cassette.