Beninca BRAIN, Operating Instructions Manual

12

13

MENU

FUNCTION

Settable values

ON-OFF-(Default)

MEMO

LOGIC

1mot

Select the 1/2 motors operating mode:
On: only one motor (motor 1) active. Function to be used in the following cases:  
-  for single motor, to connect M1:4-5-6.
-  for two syncronized motors (for instance overhead door), to connect M1:4-5-6 

and M2:7-8-9. You need to regulate the parameters related to the motor 1, the 
limit switch entries M2 are disarmed (not activate).

Off: Both motors operating.

(OFF)

not

The calculation of residual operating time is activated or deactivated in the 
event of partial operations:
On: Calculation of deactivated time. In case of partial operations, the opera-
ting time is reset. The following operation restarts for the entire time preset by 
parameter TM1/TM2.
Off: Calculation of activated time. In case of partial operations, the operating 
time is stored in memory and then subtracted from the TM1/TM2 parameter 
value in the following operation.

(ON)

MENU

FUNCTION

RES

RESET of the control unit. ATTENTION!: Returns the control unit to the default values.
Pressing the <PG> button for the first time causes blinking of the letters RES, pressing the <PG> button 
again resets the control unit.

NMAN

Displays the number of complete cycles (open+close) carried out by the automation. 
When the <PG> button is pressed for the first time, it displays the first 4 figures, the second time it shows the 
last 4. Example <PG> 

0012 

>>>  <PG> 

3456

: made 123.456 cycles.

Example of programming

Let us suppose it is necessary to:
- set an automatic closing time (TCA) of 100s 
- activate pre-blinking 
Perform the operations described below step by step:

Step

Press

Display

Notes

1

PAR

First menu

2

TCA

First function of the first menu

3

040

Value currently set for the function selected

4

100

Set the desired value with the <+> and <-> keys

5

PRG

The value is programmed

TCA

When programming has been made, the display goes to the function just set

6

PAR

Press <+> and <-> simultaneously to go to the higher menu 

7

Log

Second menu

8

TCA

First function of the second menu

9

Pre

Press <-> several times to select PRE logic 

10

OFF

Value currently set for the function selected

11

ON

Set the desired value with the <+> and <-> keys

12

PRG

The value is programmed

Pre

When programming has been made, the display goes to the function just set

13

PAR

Press <+> and <-> simultaneously to go to the higher menu and quit programming or wait 
30s.