7
SELECTION OF THE TYPE OF ENCODING (TO. GO/HAPPY VA)
VA series transmitters can operate in either HCS or ARC mode.
This allows you to use the transmitters on systems equipped with HCS receivers.
The transmitter comes with ARC mode factory setting.
To change the encoding type press simultaneously for 20 seconds the keys T1 and T2.
After a few seconds the LED will blink, indicating the mode that you are about to enable:
2 flashes and pause of 1 second, the transmitter is to be set up as HCS
3 flashes and pause of 1 second, the transmitter is to be set up as ARC
when the LED turns on steadily lit, it means that the transmitter has changed the mode.
T1
T2
T4
LED
HIDDEN BUTTON ACTIVATION
S ome advanced features require pressing the “Hidden Key”.
In traditional transmitters, the hidden key is a button inside the container that must be pressed
with a paper clip or a piece of wire.
In new transmitters TO.GO/HAPP Y ARC, the “Hidden Key” can be accessed by pressing the
keys T1 and T2 simultaneously for at least 3 seconds.
When the LED flashes, it means that the “Hidden Key” code was sent.
Attention: If the LED flashes before 3 seconds, it means that the keys were not pressed simulta-
neously and you did not send the “Hidden Key” code
T1
T2
T4
LED
REMOTE LEARNING
Remote learning allows you to enter a new transmitter in the receiver if you have a previously memorized transmitter, without having
to access the receiver.
Therefore, you will quickly have a new transmitter that resembles the one originally stored.
It is mandatory to
operate within the reception range
of the receiver.
The procedure is different depending on the device used. There are still two possible modes:
Remote Learning In Receivers One WB/WI
Proceed as follows:
•
Press the hidden key of the transmitter saved, namely the simultaneous combination of T1 and T2 keys, for 3 seconds (the
red LED on the transmitter flashes)
•
Press within 5 seconds the key on the previously memorized transmitter corresponding to the channel to associate with the
new transmitter.
•
Within 5 seconds, press the key of the new transmitter to be associated with the selected channel.
•
The receiver exits the programming mode, check the proper operation of the new transmitter saved.
The procedure can be summarized as follows:
-Hidden key of the currently active transmitter (T1 +T2 for 3s)
-Key of the transmitter already operative with the function to duplicate (within 5s)
-Key of the new transmitter (5s)
Notes:
Remote learning is only possible with ARC and HCS transmitter, and is not possible with programmable code transmitters.
T1
T1
T1
T2
TX 1
TX 1
TX 2
20 sec
3 sec
TO.GO-ADVANCEDFUNCTIONS
>
>
>
>
