46
19) DIAGNOSTIC
PHOT
SW Close
STOP
SW Open
P.P.
OPEN
CLOSE
LED 1 : Présence alimentation de réseau
LED 2 : Centrale de commande CP.LADY alimentée correctement
À chaque entrée, un segment de l’écran est associé, lequel s’allume en cas d’activation, selon le
schéma suivant.
Les entrées N.C. sont représentées par des segments verticaux.
Les entrées N.O. sont représentées par des segments horizontaux.
Le mode de clignotement des segments SW Open (quand la barrière est ouverte) et SW Close
(quand la barrière est fermée)
20) MESSAGES D’ERREUR
Ci-après certains messages qui sont visualisés par l’écran en cas d’anomalies de fonctionnement:
Err
Erreur générique
Erreur saisie du mot de passe, mémorisation des transmetteurs.
Err1
Erreur moteur
Vérifier les raccordements moteur, moteur débranché ou qui ne fonctionne pas,
problème de la centrale de commande.
Err2
Erreur photocellules
vérifier les raccordements, l’alignement de la photocellule ou la présence d’obstacles.
err3
Erreur Encodeur absolu
Vérifier les raccordements de l’Encodeur, contrôler le fonctionnement de l’encodeur.
AMP
Intervention de capteur ampérométrique
Vérifier la présence d’obstacles ou de frottements.
THRM
Intervention du capteur thermique
Surchauffe pour fonctionnement continu excessive, attendre le rétablissement.
OVLD
Surcharge
Dépassement de la puissance maximale. Vérifier le moteur ou la présence de frot-
tements.
Enc
Encodeur
Intervention du seuil Encodeur.
Summary of Contents for LADY 5
Page 5: ...5 8 G F G F D T 7 ...