11/ 2008
BENNING CM 9
12
The BENNING CM 9 is fed by two 1.5-V micro batteries/ type AAA (IEC LR 03).
A battery change (see Figure 9) is required, if the battery symbol
5
appears
in the display
3
. When the BENNING CM 9 is switched on, a battery test is
performed.
Proceed as follows to replace the batteries:
- Switch the BENNING CM 9 off.
- Put the BENNING CM 9 face down and unscrew the screw of the battery
compartment cover.
- Lift off the battery compartment cover (in the area of the housing slots) from
the bottom part of the battery compartment.
- Remove the discharged from the battery compartment.
- Then, insert the batteries into the battery compartment at the provided plac-
es (please observe correct polarity of the batteries).
- Lock the battery compartment cover into place on the bottom part and tight-
en the screw.
see figure 9:
battery replacement
Make your contribution to environmental protection! Do not
dispose of discharged batteries in the household garbage.
Instead, take them to a collecting point for discharged batteries
and special waste material. Please inform yourself in your
community.
9.4 Calibration
To maintain the specified precision of the measurement results, the instrument
must be recalibrated at regular intervals by our factory service. We recommend a
recalibration interval of one year. Send the appliance to the following address:
BENNING Elektrotechnik & Elektronik GmbH & Co. KG
Service Centre
Robert-Bosch-Str. 20
D - 46397 Bocholt
10. Environmental notice
At the end of the product’s useful life, please dispose of it at appro-
priate collection points provided in your country.
