7
Start by lowering the tube as far as possible and then raise it until you find the best
angle. For optimum, we recommend a minimum distance of 18 cm between the base
of Kitcool and the floor, in sitting position. The distance is given on
an indicative basis and depends on the wheelchair settings.
TILT ADJUSTMENT
HEADREST ADJUSTMENT (FOR KITCOOL 2.0 AND KITCOOL 2.0 MINI)
CUSHION ADJUSTMENT (FOR KITCOOL 2.0 AND KITCOOL 2.0 MINI)
3 ADJUSTMENT POINTS
9.
Lock the 2 clamps and 2 screws
You can use the graduations marked on the tubes to guide you.
Caution: never go past zero
If you fold the headrest down and then
straighten it again, the adjustments are
retained!
Correct adjustment at
shoulder level is ideal!
KITCOOL 2.0 is installed, now you can sit in the wheelchair and
tilt the chair back to relaxed position.
To increase or reduce the tilt angle:
• Undo the magnetic pin and adjust the telescopic tube.
The higher you raise it, the greater the tilt angle.
• Adjust the headrest by loosening the tightening
buttons
• Undo the Velcro strip and make a fold in the
bottom of the cushion, then reposition the
Velcro strip to hold it all
• Adjust the position of the cushion
10.
Once the adjustments have been done, tighten all the screws!
Then you can use KITCOOL 2.0.
advice
advice
You can then repeat some adjustments to find the ideal position.
The final position should be completely comfortable; if not, this means the adjustments
are incorrect.
For a better comfort in reclining position,
make sure wheelchair brakes are on.
