Commissioning
- 10 -
Connect the timer to a suitable power outlet.
Press the "RESET button" with a pointed object to fully reset the timer.
Set current time:
1. Keep the "CLOCK" button pressed and at the same time press the "WEEK" button repeatedly until the desired
day of the week appears at the top of the display (you will see English abbreviations for weekdays - an ex
planation of the abbreviations can be found) under "Definition of weekdays" page 11).
2. While holding down the "CLOCK" button, press the "HOUR" button repeatedly until the desired hour is
displayed.
3. While holding down the "CLOCK" button, press the "MIN" button repeatedly until the desired minute is
displayed.
Set time programs:
1. Briefly press the "PROG" button. The lower left corner of the display now shows the number 1 with the addition
"ON". This means that you now set the time for the 1st time program in which connected devices are to be
switched on.
2. Now press the "WEEK" button repeatedly until the desired day of the week or the desired day combination
appears on the upper edge of the display (you can see a list of the preset day combinations under "Day
combinations" on page 11).
3. Now press the "HOUR" or "MIN" button to set the desired hour or minute.
4. Press the "PROG" button again. The lower left corner of the display now shows the number 1 with the addition
"OFF" - This means that you now set the time for the 1st time program in which connected devices should be
switched off.
5. Now program the time and day setting using the "WEEK", "HOUR" and "MIN" buttons as in the previous
steps 1-3.
6. Now press the button "PROG" one last time to complete the configuration for your 1st time program.
7. It now appears the numeral 2 with the addition "ON" in the lower left corner of the display. You can repeat the
configuration steps until you have set all possible or desired time programs. If you do not want to set further
time programs, press the "CLOCK" button to exit the menu and to be able to see the current time again.
Note:
You can configure up to 8 time-programs individually. Avoid overlapping the set times of all time programs
to prevent unwanted switching on and off of connected devices
Activate and deactivate set time programs:
You can deactivate (pause) and reactivate set time-programs and their on and off times. To do this, press the
"PROG" button repeatedly until you have selected the desired time-program and the desired switch-on and
switch-off time (desired digit with the addition "ON" or "OFF" in the lower left corner of the display). Now press the
"R" button to deactivate the program or the time setting. Pressing the button again ("R") reactivates the program
or the time setting.
