Installation
Hardware Installation
To insert the network card into your PC, follow the steps below:
1. Turn off the computer and remove its cover.
2. Insert the card into a PCI slot.
3. Secure this card to the rear of the computer chassis and put back the
computer cover.
4. Connect the card to the network using twisted-pair cable.
Hardware Requirement for Wake on LAN
y
If your motherboard supports the PCI 2.1 only, then the motherboard
must provide a 3-pin WOL connector. (Some computers may require
you to change a setting in your computer’s BIOS or setup program to
enable the WOL feature.) If the motherboard supports PCI 2.2, we
don’t need the 3-pin WOL connector. (The function will be provided
from the PCI bus directly)
y
ATX 2.01 power supply.
Note: Install only one active WOL adapter per computer. You can install additional,
non-WOL adapters.
Hardware Installation for Wake on LAN
If your motherboard supports the PCI 2.2 standard, no other procedure is
needed. But, you still can follow the steps (for PCI 2.1) below on the PCI
2.2 motherboard, and all the function include the WOL will work
normally.
