27
Installation
Reset the Host using the following steps:
1. Connect the power port on the Host to a power source and wait for at least 90 seconds.
2. Poke the
RESET
hole at the rear of the Host with a pin for at least 5 seconds.
3. The Host LED will begin quick flashing red (flash red twice every second) for 10 seconds, then
light up static white for 3 seconds, indicating that the Host is resetting.
4. Once the Host LED lights up static green the resetting process is complete.
Resetting a Button
Resetting a Button allows you to return the Button to its original factory settings. You may want to
reset a Button because of either one of the following conditions:
• You purchased an additional Button (via a Button Kit) which has not been paired to a Host.
• A Button that was included in the original package has been paired to a different Host (one which
was not originally included with the Button in the package), and you want to quickly pair it back to
its original Host.
• A Button that was included in the original package has been paired to a different Host (one which
was not originally included with the Button in the package), and you want to re-pair the Button to
its original Host while the Host is not powered on.
Reset a Button using the following steps:
1. If the original Host is powered on, place the Button within range of the original Host and ensure
the LED on the Host is static green.
After the Host has been connected to a power source for at least 90 seconds, the Host
LED may indicate any one
of the statuses described in
LED indicators of the Button and the Host
. As long as the Host
has been connected
to a power source for at least 90 seconds, you may proceed to the next step of the resetting process regardless
of the status of the Host
LED.
Do not disconnect the Host from its power source at any time during the resetting process.
