Installing additional memory
40
7. Gently push the free edge downwards until the module locks into
place.
If the memory module is not installed properly, your Joybook may not
boot properly.
8. Replace the cover.
9. Use a screwdriver to secure it with the screws.
10.Place the battery on its original position (1) and then slide the battery
retainer A to the to the lock
position (2). Connect the AC adapter.
When you start Joybook, it will automatically test and configure the
new memory.
It is recommended that you go into BIOS to load setup defaults after
installing additional memory. For details, refer to
"Using BIOS setup" on
page 29
.
Battery retainer A
JB_S31V.book Page 40 Wednesday, February 7, 2007 6:10 PM