Operation
24
Press to highlight
Power On Lock
and press / to select
Off
. You will
not have to enter the password next time when turning on the projector.
ii. If the password is incorrect, the password error message displays lasting for
three seconds, and the message
“INPUT PASSWORD”
displays for your
retry. You can press
MENU/EXIT
to cancel the change or try another
password.
Though the password function is disabled, you need to keep the old password in hand should you ever need to
re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time. When starting up, the projector automatically searches for
the available signals.
Be sure the
Quick Auto Search
function in the
SOURCE
menu is
On
if you want the
projector to automatically search for the signals.
To select the source:
1.
Press
SOURCE
on the projector or remote
control. A source selection bar displays.
2.
Press
/
until your desired signal is selected
and press
MODE/ENTER
.
Once detected, the selected source information
will display at the corner of the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2 to
search for another signal.
•
The brightness level of the projected image will change
accordingly when you switch between different input signals.
Data (graphic) "PC" presentations using mostly static images
are generally brighter than "Video" using mostly moving
images (movies).
•
The native display resolution of this projector is in a 16:10 aspect ratio. For best display picture results,
you should select and use an input signal which outputs at this resolution. Any other resolutions will be
scaled by the projector depending upon the “aspect ratio” setting, which may cause some image distortion
or loss of picture clarity. See
"Selecting the aspect ratio" on page 25
for details.
Changing Color Space
In the unlikely event that you connect the projector to a DVD player via the projector’s
HDMI
input and the projected picture displays wrong colors, please change the color
space to
YUV
.
To do this:
1.
Press
MENU/EXIT
and then press / until the
SOURCE
menu is highlighted.
2.
Press to highlight
Color Space Conversion
and press / to select a suitable
color space.
This function is only available when the HDMI-input port is in use.
Computer1/YPbPr1
Computer2/YPbPr2
HDMI
Video
S-Video
Network Display
