10
PM060
PM060
PM060
PM060M
M
M
MW
W
W
WR
R
R
R / PM060
/ PM060
/ PM060
/ PM060MBR
MBR
MBR
MBR
Secure each module to the structure using four stainless steel bolts, with nuts, washers, and
lock washers. When using this mounting option, only the existing mounting holes (with the
current diameter of 9mm
9mm
9mm
9mm) can be used for module to meet 5400Pa design strength under UL
1703.
PM
PM
PM
PM060M01
060M01
060M01
060M01
Secure each module to the structure using four stainless steel bolts, with nuts, washers, and
lock washers. Only the existing mounting holes (Diameter: 6.
6.
6.
6.6
66
6mm
mm
mm
mm) that can be used for
module to meet 3600Pa design strength under IEC 61215/ IEC 61730 and to meet 2400Pa
design strength under UL 1703.
PM
PM
PM
PM072
072
072
072P
P
P
PW
W
W
W0
00
0 / PM072MW0
/ PM072MW0
/ PM072MW0
/ PM072MW0
Secure each module to the structure using four stainless steel bolts, with nuts, washers, and
lock washers. When using this mounting option, only the existing mounting holes (with the
current diameter of 8
88
8mm
mm
mm
mm) can be used for module to meet 5400Pa design strength under UL
1703.
PM
PM
PM
PM072
072
072
072P
P
P
PW
W
W
WA
A
A
A
Secure each module to the structure using four stainless steel bolts, with nuts, washers, and
lock washers. When using this mounting option, only the existing mounting holes (with the
current diameter of 8mm
8mm
8mm
8mm) can be used for module to meet 5400Pa design strength under IEC
61215/ IEC 61730.
PM096B00
PM096B00
PM096B00
PM096B00
Secure each module to the structure using four M6 (¼”)
M6 (¼”)
M6 (¼”)
M6 (¼”) stainless steel bolts, with nuts,
washers, and lock washers per module. Only the mounting holes that are 322mm (12.6772
inches) from the short end of the module can be used for the module to meet 5400 Pa design
strength.
3.2 Mounting with Clamps
•
Clips and clamps are not provided by BenQ Solar.
•
The clamping clips on the side frame must be in parallel – equidistant from the closest
module frame corner (see Figure 1).
•
Ensure the clamps are of sufficient design strength to allow for the maximum design
pressure of the module.
