16
Chapter
Chapter
Chapter
Chapter 4
44
4 Wiring
Wiring
Wiring
Wiring, Connecting
, Connecting
, Connecting
, Connecting and Grounding
and Grounding
and Grounding
and Grounding BenQ Modules
BenQ Modules
BenQ Modules
BenQ Modules
4.1 Wiring & Connecting
DO NOT do any change or adjustment on the cable of Junction Box.
DO NOT disconnect DC Cables alone, someone should always be nearby!
DO NOT disconnect/connect modules while they are under load!
DO NOT assemble the connector with wet or dirty hands.
Always make sure that all locking connectors are fully engaged and locked. Otherwise faulty
connetions can result in arcs, electrical shock, and equipment damage.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
Do not bend the cable directly behind the contact point. A minimum bending radius of r≥4x
(static steady), r≥5x (dynamic) cable diameter must be maintained. The cable must be routed
in a way that tensile stress on the conductor or connection(s) is avoided.
Table1 PV Cable Feature
Table1 PV Cable Feature
Table1 PV Cable Feature
Table1 PV Cable Feature
Figure
Figure
Figure
Figure 4
44
4 The minimum bending radius of cable
Pay attention to the following when wiring:
Pay attention to the following when wiring:
Pay attention to the following when wiring:
Pay attention to the following when wiring:
1.
1.
1.
1.
Correct wiring scheme
Correct wiring scheme
Correct wiring scheme
Correct wiring scheme
Check that the wiring is correct before commissioning the system. If the measured open
circuit voltage differs from the specifications, then there is a wiring fault. Ensure that the
polarity is correct.
