Last revised: May 17, 2013
5
Chapter
Chapter
Chapter
Chapter 3
33
3 Installation
Installation
Installation
Installation
Please see the Handling and Installation Guidelines in Chapter 1 for more information.
3.1 Choose a Suitable Location
Modules may be installed at any angle from horizontal to vertical. Select the appropriate
orientation to maximize sunlight exposure.
The modules should not be shaded; shading will affect module output significantly.
Constant module shade can cause module “hotspots” which could shorten the life of the
product over extended periods of time.
Module should never be fully submerged or installed on a mobile location (i.e. boat).
3.2 General Installation Guidelines
Do not remove or alter the module frame, doing so may void product warranty.
Additional mounting holes may damage the module and compromise frame strength.
The gap between the module and system structure and ground is required to prevent
wiring damage and allows air to circulate behind the module.
* Traditional mounting systems require a gap between two modules that has a minimum
20mm for common use.
**** Does NOT apply to installations
Does NOT apply to installations
Does NOT apply to installations
Does NOT apply to installations using
using
using
using ZEP
ZEP
ZEP
ZEP Mounting System.
Mounting System.
Mounting System.
Mounting System.
BenQ Modules can be installed in landscape layout.
Avoid exposing the back of the module to direct sunlight.
Any installation must comply with all applicable Building, Electrical and Fire Department
Rules and Regulations.
Do not install the modules where there may be flammable gases or vapors, since sparks
may be produced.
BenQ Modules can be installed using any option described in the Mounting Options
section, including the Zep mounting system, per the instructions in this manual.
Not mounting the modules as directed in this manual may void the product warranty.
All screws and/or clamps used to secure the modules must be rated for this use.
