Basic operations
29
Initial setup
After you have connected the display to the power, you are ready to power on the
display. The first time you power on the display, you will be guided through a series of
setup screens. Follow the on-screen instructions or the steps below to start up your
display and complete the initial setup.
1. Turn on the display. Wait for the display to boot up with the BenQ screen. This may
take a moment.
2. Tap
Next
on the screen to begin. Follow the on-screen instructions to set up the
language, date and time, and network. Or your can skip some of these steps and
complete the setup later.
OSD Setting
Use one of the following methods to enter the OSD menu:
• Press
on the remote control.
• Press the
Menu
button on the front panel.
• Drag the
OSD
menu up from the bottom-center of the screen.
Refer to
for more information on the OSD menus and their
settings.
Switching input signals
Under the
Connection
tab of the OSD menu, you can select a desired input source.
Refer to
for more information.
