35
Base-2
Security Panel
ENGLISH
P
ROGRAMMING
Base-2 can be programmed via the on-board DIP Switch strip [
12
]. This section
describes the programming procedure.
Alarm Time
Using switches 1 and 2 program the Alarm Time, as per the following table. The
OFF time is already programmed at 5 seconds (at Factory).
Alarm Cycles
Using DIP Switch no. 3, program “Persistent Alarms” to generate either a single
Alarm cycle (at Factory), or Repetitive Alarm Cycles (i.e. until Standby status
is restored), as follows.
Zone 1 Delayed
Using DIP Switch no. 8 program the Zone 1 as either “Delayed” or “Instant” , as
follows.
Entry and Exit Times
If Zone 1 is programmed as “Delayed”, using DIP switches 5, 6 and 7 set the
Entry and Exit Times, as follows.
ZONE 1 OPERATING MODE 1
DIP SWITCH 8
Delayed (at Factory)
OFF
Instant
ON
ALARM TIME
DIP SWITCH
1
2
1 minute (at Factory)
OFF
OFF
3 minutes
OFF
ON
5 minutes
ON
OFF
10 minutes
ON
ON
RELAY 1 MODE FOR
PERSISTENT ALARM ON ZONE
DIP SWITCH 3
Single cycle (at Factory)
OFF
Repetitive Cycles
ON
Programming the Panel
