30
GSM/GPRS Alarm Communicators
6.
Complete the connections on the terminal blocks [
10
].
7.
Following the arrow, insert the SIM-CARD [
8
] face down in the SIM holder [
6
] (see Figure 1).
!
!
!
!
!
The SIM-CARD PIN must be disabled before the card is inserted into the Communicator.
8.
Make sure that all the green LEDs flash when the product is switched on; this means the Communicator is in its initialisation phase.
9.
Checking Signal Strenght :
– make sure that at least one of the green LEDs remains lit; all green LEDs lit indicates optimal coverage;
– if the green LEDs are not illuminated, the signal strength is TOO WEAK; change the position of the antenna until you
find a position which offers acceptable signal strength, at least one LED illuminated.
10.
Close the control panel cover.
,
,
,
,
,
Connect power circuit only after the cabinet has been secured to the building or structure and has been
connected to the protective earth ground of the building.
!
!
!
!
!
Before inserting or removing the SIM card, please ensure the unit is powered down.
ANT-EU Remote antenna
For details of how to fit the remote
ANT-EU
outdoor antenna, please refer to the instructions supplied with the product. The
ANT-EU
is used to provide the Communicator a excellent GSM signal strength.
BGSM-100BA or BGSM-120BA
See figure 1.
1.
Mark the position of the holes [
19
] required to fix the metal base [
17
] to the wall.
2.
Drill holes in the wall as marked.
3.
Insert the 4 P.C.B. supports [
16
] into the holes on the metal base [
27
].
4.
Feed the connection cables through the opening on the base [
22
].
5.
Fix the metal base to the wall using wall anchors (not supplied).
!
!
!
!
!
Make sure you do not damage
wiring or pipes in the chase.
Fig. 2 - Mounting of electronic card inside the control panel.
