BGSM-100/120
41
G
G
G
G
G
The section shared by the
BGSM-100
and
BGSM-120
series includes the following pages.
Phonebook
: Telephone contact list page.
Options
: Options page.
GPRS
: GPRS parameters page.
Status
: Page used to check the status of the Communicator.
PTM
: PTM function setup page.
The following pages only apply to the
BGSM-120
Communicator series.
I/O
: Communicator output/input parameter programming page.
Voice Dialer
: Page used to set all parameters relating to the voice dialer.
SMS Dialer
: Page is used to program all SMS dialer options.
Voice Message
: Page used to manage voice messages.
To start the configuration of a new Customer, click on
File->New.
To display the list of customers stored in the archive, select the menu command
File->Open
. This section will allow you
to delete or retrieve configuration data, as follows:
1.
Using the right button on the mouse, click on the Customer’s name.
2.
Click
Load
upload the respective data from the Hard-Disk, or
Delete selected customer
to delete the data
configuration.
You can load the configuration data by double clicking the respective name field.
You can list Customers in alphabetical or code order by clicking the heading of the column concerned.
The configuration data are grouped in the following pages. The (
Status
) page is for “Supervisory and Control” purposes. All
the pages are described in detail in this section.
Phonebook
The Telephone Page phonebook holds 100 telephone numbers.
Description:
Enter an alphanumeric string of up to 16 characters.
Telephone number:
Enter a telephone number of up to 16 digits, preceded by the correct international prefix in the format
"+xxx" (only digits and “+” signs are accepted).
Activates Output:
select the telephone numbers which can activate the outputs T1 (OC1), T2 (OC2) and T3 (OC3) when
the Communicator receives a call from them. This function does not depend on the
White List
or
Black List
options
(Options page->Dial options)
.
,
,
,
,
,
In the BGSM-100 series, it is possible to only activate the T3 output (OC3).
,
,
,
,
,
To activate the output in the BGSM-120 series, programme the T1 (OC1), T2 (OC2) and T3 (OC3) terminals as
"Output" and enable "Reserved Output" (see pages referring to I/O->Type and I/O->Reserved Output).
Ouput Activation Confirmation
: this option is only available for the BGSM-120 series; tick this box to receive a
confirmation ring once the output has been activated.
,
,
,
,
,
CAUTION:
— the ring will be received 1 minute after the output has been activated;
— if the transmitter is already in operation (for example: the GSM channel is busy with a voice communication),
the confirmation ring will not take place;
— the option “Ouput Activation Confirmation” cancels the incoming call after approximately 5 s, even if the
"Black list" option is not enabled.
White List:
Enable
or disable
the
White List
area would allow the Communicator to accept or refuse incoming
calls. The functioning mode of the
White List
option is linked to the
selection or non-selection
of the
Black List,
area which is present on the inside of the
Options page->Dial options,
as seen in the following table:
