27
®
G
G
G
G
G
SMS Dialler Page
This page will allow you to program the SMS Dialler functions and Messages and also set up the ‘Special Functions’ of the
3 Input lines.
,
,
,
,
,
The configuration data on on this page concerns the first eight telephone numbers entered on the “Telephone”
page.
Main window
The column on the left-hand side of the Main window shows the events which, if duly programmed, will generate two SMS
text messages: one for activation and the other for restoral (the ‘Periodic SMS text message can generate the activation
message only).
Polarity: (this column shows the events which unbalance the 4 Input lines), select the Standby polarity of the Inputs
— H-Normally Open or L-Normally Closed.
Telephone Numbers: click (tick) the check boxes of the numbers to be called when the respective event occurs.
SMS: write the Activation and/or Restoral message to be sent when the respective event occurs (maximum 100
characters). If no message is required, leave the respective box empty.
Serv: If this option is enabled, unbalance (on Input Lines 1, 2 and 3) will generate actions instead of calls. Two actions
can be set up for each Input Line, as per the following table.
Input line no.
S elect
S pecial Functions
1
A
E nable/D isable P eriodic Message
If this option is selected — and Input Line 1 is held in a permanent state of Unbalance, the BGSM-I will
send the Periodic Message at regular intervals (in accordance with the values in the
Periodic Message section). If Input Line 1 restores to standby status (Input Line 1 balanced) the BGSM-I will
not send the Periodic Message
B
S end P eriodic Message now
If this option is selected, the BGSM-I will send the Periodic Message immediately and start the interval
between messages
2
A
C lear C all Queue
B
Restore Reserved Outputs to Standby
3
A
S witch to GS M
B
Reserved (A lternative D ialling)
Priority
This section will allow you to select the operating priority of the BGSM-I: Interface (at default) or SMS Dialler/Contact ID
Communicator.
Pay-as-you-go Balance message
,
,
,
,
,
NOTE: The Manufacturer shall not assume responsibility for Pay-as-you-go credit services managed by
GSM Network Providers.
If you enable this option, an SMS text message — containing information provided by
the GSM Network
regarding the end-
user’s credit balance — will be sent to the first number in the Telephone Number list. Enter the number of telephone calls
(ContactID reports and/or outgoing SMS text messages) the BGSM-I must allow before checking the Pay-as-you-go balance.
Pay-As-You-Go Balance message - If you click on this button the application will open a window showing the remaining
credit balance (if this service is managed by your network provider), or a message indicating that this service is not
available.
Periodic message
This section will allow you to set up the Periodic message options.
Date of first Periodic message - Select the Date of the first Periodic message.
Time of the first Periodic message - Select the Time of the first Periodic message.
Interval - Enter the interval (DD-HH-MM) between each Periodic message. Accepted DAY values: 0 to 693.
