27
The following attributes can be programmed for each of the Alarm lines:
r
Call Sequence
for Telephone numbers 1 through 8
r
Event
Code
r
Trigger signal edge
: Rising or Falling (for External Alarm lines and the
Internal TAMP line)
r
Stop call cycle
(if this attribute is programmed, the Alarm cycle will stop
after first successful Alarm line call)
r
Telephone numbers
to call in the event of an alarm
r
User Code
(to be assigned to each Telephone number)
r
Reporting Protocol
r
Dialling mode
(DTMF or Pulse)
The GTCOM can be programmed via the
GTCOM
Software Application, from
Bentel Security Suite
Software Package (runs under Windows 3.1 or higher).
The optional Software Application, with graphic interface, provides a fast
trouble-free way of programming the device.
The programmed data of each installation can be saved in the database, for
retrieval and reuse in other systems.
INTRODUCTION
