22
Bentone
5.3 Replacement of damper motor
Removal and installation
1.
Switch off the mains power.
2.
Carefully note the placement of the cables in the damper motor and
then disconnect them.
3.
Remove the damper motor as described in the section on servicing the
air damper.
4.
Remove the damper from the damper axle (I)
5.
Remove the damper motor from the mounting plate.
6.
Mount the damper to the damper axle.
7.
Install the new damper motor on the mounting plate.
8.
Connect the damper motor’s cables.
9.
Re-install the damper motor and mounting plate on the air intake
according to the instructions on servicing the air damper.
10. Turn on the mains power.
11. Check/adjust the combustion.
!
If the burner is directly connected, ensure that all
components on the burner are without power.
!
Carefully note the
placement of the
cables before dis-
connecting them.
I
