4
Bentone
172 515 01-2 2021-10-05
1. General Information
The burner may only be used for its intended purpose in accordance with the
product’s technical data.
We reserve the right to make design changes and cannot be held liable for any
misprints or typographical errors.
Modifying the design or using accessories or components that have not been
approved by Enertech in writing is strictly prohibited.
This Installation and Maintenance manual:
•
is to be regarded as part of the burner and must always be kept near
the installation site.
•
must be read prior to installation.
•
is intended for use by authorised personnel.
1.1
Delivery inspection
•
Make sure everything is delivered and the goods have not been
damaged during transit. Transport damage should be reported to the
shipping company.
•
If something is wrong with a delivery, report it to the supplier.
1.2
Safety
- before installation:
•
Installation and work on the burner and associated system
components may only be carried out by persons who have undergone
relevant training.
•
The product is packaged to prevent damage from occurring when
handled – Handle the product with care! Lifting equipment must be
used to lift larger packages.
•
The products must be transported/stored on a level surface in a dry
environment, max. 80% relative humidity, no condensation.
Temperature -20 to +60 °C.
- installation:
•
The burner must be installed in accordance with local regulations for
fi re safety, electrical safety, and fuel distribution.
•
The premises must comply with local regulations pertaining to use of
the burner and must have adequate air supply.
•
The installation site must be free of chemicals.
•
Fire extinguisher with Class BE recommended.
•
Make sure when installing the burner that there is enough space to
service the burner.
•
The electrical installation must be professionally carried out in
accordance with current mains electricity regulations and in a
professional manner.
•
Make sure that the burner is suitable for the application (see Technical
Data).
•
All components must be installed without being bent, twisted or
subjected to mechanical or thermal forces that affect components.
