75
Bentone
Y
Z
X
!
With the warm settings, the burner is started up after pressing the Info
/reset
button .
Air-fuel ratio control can now be accurately set while the flame is present on the respective
component on the burner, see chapter "Burner settings".
P
V
h min s
%
Bi
ld
9
4
/0
7
0
7
Press
/reset
to select parameter
400
for initial commissioning.
P
V
h
min s
%
Bi
ld
1
1
3
/0
7
0
7
Identification of start for setting the curve parameters.
9.4.2
Adjusting settings of previously set automatic
control unit
Check that the burner is connected to gas and has gas pressure.
Check that the burner is connected to an electrical supply.
Turn the switch (X) to ON position, the display (Z) will be active.
Turn the switch (Y) to ON position.
Follow the description below to set the burner.
Press
VSD
F
A
> 1 second to access login mode.
To continue with the settings, you need to log into service engineer
level,
see X.3.4 Access code for service engineer level.
After login is complete, continue with the setting work as shown
below.
!
If, during the time the curve is parameterized, an error occurs which leads to safety
shutdown, parameterization of the curve is quit.
Summary of Contents for STG 146i/2
Page 34: ...34 Bentone 6 2 Wiring diagram...
Page 123: ......
Page 124: ...Enertech AB P O Box 309 SE 341 26 Ljungby www bentone com...
