79
Bentone
Display: Value
0
Press
/reset
to backup process.
Press
+
to shift the value in change mode 1 position to the left.
Display: Value
1
flashes
!
Note! The value must be set to 1 if a backup is required, and to 0 if a backup is not
required.
The values higher than 1 which can be set must not be used.
Press
/reset
to activate the backup process.
Display
: 1
appears
After about 5 seconds (depending on the duration of the program),
0
appears on the display, indicating the end of the backup process.
Display:
0
!
If an errror occurs during the backup process, a
negativ value is displayed. For error diagnostics,
the cause of the error can be determined from
the diagnostic code of error message 137 (see
Error code list)
Press
ESC
-
+
four times until the top menu is displayed.
!
To detect potential dispalay
errors, the value is displayed 1
place shifted to the left
Summary of Contents for STG 146i/2
Page 34: ...34 Bentone 6 2 Wiring diagram...
Page 123: ......
Page 124: ...Enertech AB P O Box 309 SE 341 26 Ljungby www bentone com...
