ATIS TOP - Fancier
COURSE OF OPERATION
8
HB_TOP_ZUECHTER-E_22.doc
Gantner Pigeon Systems GmbH
2. COURSE OF OPERATION
2.1 Registrations of the Pigeons at the Club
The fancier takes his pigeons and his ATIS TOP to his club.
There the ATIS TOP is connected to the Clubsystem III. With a special authorization key,
which is held over the loft antenna for reading, the ATIS TOP is made ready for the
registration of the pigeons.
The association ring number as well as all further data are entered into the PC. Then the
corresponding pigeon is held over the antenna with its chip-code-ring. By this the
association ring number and the other data are written into the chip-code-ring.
A short beep and a display on the screen of the PC confirms the correct transfer. The
corresponding data are also entered into the connected ATIS TOP, into the list of registered
pigeons.
For further control a list of the registered pigeons can be printed out.
2.2 Preparations for a Race at the Fancier’s
When preparing a race the pigeons that are to take part have to be marked for a particular
race. (This is only necessary when more than one flight is to be prepared!)
For this purpose the pigeons that are to take part in the race are selected from the list of
registered pigeons (see also chapter 11).
On the display of the ATIS TOP the function
„mark“(associate)
is selected from the main
menu using the cursor keys (directional arrows). You are then asked if you want automatic
or manual marking (association). After selecting the marking mode /association mode) you
still have to enter the race number.
In the case of automatic marking (association) you`ll then get the instruction to pass the
selected pigeon over the loft antenna. A short beep from the ATIS TOP confirms that the
pigeon has been marked (associated) for that particular flight.
