BENZING M1 – Fancier
INSTALLATION AND INITIAL OPERATION
HB_BENZING-M1_ZUECHTER-E_13.doc
17
GANTNER Pigeon Systems GmbH
• When operated in the battery mode the BENZING M1 cannot be used with a
fancier system (which means with connected lazer loft antennae) as the
power supply for the antennae would not be sufficient.
• The plugs of the connection cable should be fitted tightly into the sockets. If
interference with the antennae occurs, check these connections!
Note:
Also loft antennae of the SAN type can be connected to the BENZING M1. The loft
antenna SAN is the preceding version of the lazer loft antenna (PLB).
3.2.1 Using the BENZING Station in the Fancier System
The BENZING M1 can also be connected to the fancier system by using a BENZING Station.
In this case all devices of the fancier system like the lazer loft antennae (PLB), printer etc.
will be connected directly to the BENZING Station.
Figure
3.2 - Connection of the BENZING Station in the Fancier System
1
Additional Power Supply. But it is recommended to apply power as near to the lazer loft
antennae (PLB) as possible (see previous section with figure 3.1).
2
Connection of the lazer loft antennae via DB 9 socket.
3
PMDIN socket for existing components (SAN, INN, CNN, ANN etc.).
4
Parallel printer port for connection of conventional printers.
5
DB 9 socket for connecting a mobile phone or GSM modem.
6
DB 15 socket for connection with the BENZING M1. The BENZING M1 is plugged into the
BENZING Station as shown in figure 3.3.
