Beper 50.971, Use Instructions

14

Steam station Use instructions

Front & Rear support

You can put the iron on the front & rear support during operation and you can also secure the iron 

into front & rear support for storage after finishing ironing.

Power button

Plug in the appliance and press down the Power button, the power indicator will be illuminated, also 

the low steam level regarded as defaulted one and its indicator will flash. Press down the Power 

button for a while, both the power indicator and low steam level indicator will be extinguished, and 

the appliance will be disconnected from the power supply.

Steam level control button

The steam level can be selected low, medium or high with the steam level control button. Any one to 

be selected, its indicator will flash, after a few minutes, the indicator will be changed to illuminating. 

At this time, the appliance can produce steam and you can use the steam for ironing.

Temperature dial

Turn the dial to set ironing temperature to meet the garment changed.

Temperature indicator

When the iron is heating up, the temperature indicator will be illuminated. Once the iron has reached 

the selected temperature, it will extinguish. The temperature indicator will be cycled on and off as the 

iron maintains the selected temperature during ironing. 

Steam trigger

After pressing down the Power button and choosing the desired steam level, it indicates the ste-

am  can  be  used  for  ironing  until  the  corresponding  steam  level  indicator  is  changed  flashing  to 

illuminating. At this time, press the steam trigger with a little force, the steam will be sprayed from 

the soleplate continuously. When loosen the steam trigger, the appliance can only be used for dry 

ironing without steam.

Lack of water indicator and reset button:

If less water in the tank, the indicator will be illuminated, following with two beeps can be heard, the 

steam generator stops working. It prompts you need to add water into the tank.

If less water in the tank, the lack of water indicator will be illuminated, at that time, you need to refill 

the water tank. After refill the water tank with water, press the reset button once to make the lack of 

water indicator be extinguished and then you can release steam for ironing. 

Descaling indicator & De-calc box

If the descaling indicator illuminates, it indicates the mineral deposits in the de-calc box has been 

collected to a degree and you should replace the de-calc box in time.