Beper 50.971, Use Instructions

15

Steam station Use instructions

BEFORE FIRST USE 

1. Remove any sticker, protective foil or storage cover from the soleplate.

2. Heat up the iron to maximum temperature and iron over a piece of damp cloth for several minutes 

for the purpose of removing any residue on the soleplate according to the section of “Steam ironing”.

3. Before first use, detach the de-calc box and then immerse it into the water for more than one 

minute.

NOTE

: It is normal that strange odor comes out from the unit for the first use. This will cease after 

a short while.

NOTE

: Some particles may come out of the soleplate when you use the iron for the first time. This is 

normal; the particles are harmless and stop coming out of the iron after a short while.

NOTE

: When you switch on the appliance, the steam generator may produce a pumping sound. This 

is normal; the sound tells you that water is pumped into the steam generator.

NOTE

: During the heating process of the soleplate, there will be little steam coming out from the 

soleplate automatically and this phenomenon will continue for about 3 seconds, This is normal.

USING YOUR STEAM STATION IRON

The appliance has two iron portions. You can use dry ironing or steam ironing. The details refer to 

the following:

Dry ironing

1. Put the iron on the thermal insulating cushion.

2. Connect the plug to wall outlet, together with one beep can be heard. And then press down the 

Power button, the power indicator starts to illuminate.

3. Turn temperature dial to your desired setting, which is depended on the fabric of garment, and the 

temperature indicator will illuminate. Refer to IRONING TIPS latter. The iron starts heating.

4. When the temperature indicator turns off, the selected temperature is reached. You now can start 

ironing. 

WARNING: Never touch hot soleplate at any time before cooling down!  

Steam ironing

1. Grasp and press the water tank’s handle to take out of the water tank, then open the filling apertu-

re cap and fill water into the water tank. You had better use purified water with less calcium particles. 

After it, close the filling aperture cap. The max capacity of water tank is 1.2L, the water level shall 

not be exceeded the MAX mark. 

2. Replace the detachable water tank properly.

3. Put the iron on the thermal insulating cushion.

4. Connect the plug to wall outlet, together with one beep can be heard. And then press down the 

Power button, the power indicator starts to illuminate, also the low steam level regarded as defaulted 

one and its indicator will flash. And you can select other steam level by pressing the steam level 

control button according to your requirement. When being selected, its corresponding indicator will 

flash.Make sure that there is enough water in the tank.

5. Turn temperature dial to your desired setting, which is depended on the fabric of garment, and 

temperature indicator will illuminate. Refer to IRONING TIPS latter. 

6. The water in the tank will be heated, after a few minutes, the temperature indicator will be extingui-

shed, which indicates the soleplate temperature has achieved the selected temperature. And when 

the indicator of selected steam level has been changed flashing to illuminating, it indicates you can 

take out of the iron and iron the garment with steam by pressing the steam trigger of the iron.

Caution: 1) Do not touch hot soleplate at any time before cooling down!

2) Don’t emit the steam directly to the people.