Patio quartz Heater with Floor Stand Use Instructions
EN
9
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Product description Fig. A
1 Heating elements assembly
2. Fixing knob for heating elements assembly
3. Support for heating elements assembly
4. Power selection indicator
5. Pull switch
6. Pole cover
7. Upper pole
8. Pole fixing screws (3x)
9. Middle pole
10. Pole fixing screws (3x)
11. Lower pole
12. Power cable clamp
13. Power cable
14. Base fixing cover
15. Screws for base (4x)
16. Base assembly
17. Floor fixing kit (3x screws; 3x anchors)
Warnings for use
Remove all packaging materials before assembling and using the appliance, making sure to keep them out of
the reach of children and pets.
Never touch the heating elements assembly when the appliance is operating: risk of burnings.
Do not tilt the heating elements assembly when the appliance is operating. Wait at least 15 minutes after the
appliance has been shut off before adjusting tilt.
Do not cover the grid protecting the heating elements, to avoid any risk of overheating.
Do not use the appliance to dry clothing and linen.
After switching the appliance off, even if the heating elements are off, they can still be very hot, and thus dange-
rous. Make sure the appliance is switched off before carrying out any assembling and/or maintenance operation.
Do not attempt to modify/repair the appliance in any way.
Do not install and/or use the appliance near showers, bath tubs, swimming pools, etc.
This appliance is specifically designed for domestic use in gardens, terraces, patios, arcades and outdoor envi-
ronments in general. However, it is necessary to ensure that the plug is connected indoors, away from rainf and
other atmospheric agents.
The appliance is equipped with an anti-tilt safety switch, that automatically stops the operation fo the appliance
in case the base is not touching the ground; after replacing the appliance on the floor, the safety switch will au-
tomatically turn the appliance back on.
The height of the floor stand is adjustable up to 200 cm; however, it is necessary that the heating elements
assembly is installed at a minimum height of 180 cm when the appliance is in use.
Before moving the appliance, make sure that it is switched off and unplugged from the wall socket.
Summary of Contents for P203PAN002
Page 2: ......
