83
Operation
EN
6002782_b – 14.09.2016
4.3.1
Run-on function
The device comes with a run-on function. If this function is
used, the device will work for a further ten minutes at the last
chosen power level.
In recirculated air mode, it is necessary to use the run-on
function so that the device can remove the remaining
odours.
If using BUF-BDL recirculated air filters:
Using the run-on function increases the life of the filter filling.
The filter filling must be replaced at regular intervals.
The run-on function is switched on manually.
Touch
field
Function
The device is switched on.
☞
Touch the touch field 1x.
y
A beep sounds.
y
The remote control vibrates.
y
The LED illuminates for a short time.
y
The run-on time starts in power level 2 and
switches off after 10 minutes.
4.3.2
Extraction mode / recirculated air mode
changeover
If the device is equipped with JetStream technology, it is
possible to switch between extraction mode and recirculated
air mode at any time.
Touch
field
Function
The device is switched on.
☞
Touch the touch field 1x.
y
A beep sounds.
y
The remote control vibrates.
y
The LED illuminates for a short time.
y
The device switches to recirculated air
mode.
The device is switched on.
☞
Touch the touch field 1x.
y
A beep sounds.
y
The remote control vibrates.
y
The LED illuminates for a short time.
y
The device switches to extracted air mode.
Summary of Contents for BDL 115 SK
Page 92: ...6002782_b 14 09 2016 ...