Berbel BEH 60 FLT, Operating And Installation Instructions For The Models

26

Cleaning

6005142_0 – 24.02.2020

5. 

Cleaning

5.1 

Safety information for cleaning

D

WARNING!

Hazard through a disregard of the cleaning instructions!

This chapter contains important information for the safe 
cleaning of the device.

☞

Read through this chapter carefully before cleaning the 
device. 

☞

Follow the safety instructions.

y

Cleaning only by authorised users.

D

“1.2 Authorised target groups” (page 4).

y

No cleaning permitted by children under 8 years old and 
persons who would not be able to properly assess the 
hazards associated with handling the device.

y

After use, the hob and other parts that could be touched 
may still be hot. There is a risk of burning.

y

Grease residues should be removed. Grease residues pose 
a fire hazard.

y

With intensive cooking on the front hob plates, moisture 
may deposit on the fronts of the cabinets. The moisture 
must be removed every time after cooking, to avoid 
damage to the kitchen units.

The device should be cleaned regularly:

y

Control panel, surface, upper shell, bulging edge and 
lower shell after each cooking process.

y

With daily use, the Capillar Trap after three weeks at the 
latest.

y

The fronts of the cabinets above the device after every 
use of the front hob plates.

5.2 

Cleaning procedures

The device draws in dirt particles (e.g. grease and oil particles) 
with the air from the room. The dirt particles are separated 
and collected in the upper shell, on the bulging edge, in the 
lower shell and in the capillary trap.

Before every cleaning:

☞

Turn off the device.

☞

Make sure that the hob and other parts that could be 
touched have cooled down.

D

ATTENTION!

Danger of damage through improper cleaning!

Sharp-edged objects, abrasive or unsuitable cleaning agents 
can damage the device.
The following cleaning agents are unsuitable and must not 
be used:

y

Acetone

y

Trichloroethylene

y

Solutions on a cellulose basis (e.g. cellulose thinner)

y

Artificial resin thinner

y

Abrasive media

y

Polishes containing silicone

y

Polishes containing oil

y

Wax

y

Water vapour

y

On painted surfaces: Microfibre cloth

☞

Keep objects that could scratch the device far away from 
it (e.g. rings).

☞

Use mild household cleaner (e.g. alkali-free, pH-neutral 
multipurpose cleaner).

☞

Use a soft, damp cloth.

☞

Clean without exercising excessive pressure.

The instructions and information on the cleaning agent 
should be observed.

Control panel

☞

Clean the control panel with a lint-free, slightly damp 
cloth (e.g. a microfibre cloth).

☞

Dry the control panel with a lint-free, soft cloth.

Surfaces

☞

Clean the surfaces with a soft, damp cloth and a mild 
household cleaner.

☞

Dry the surfaces with a soft cloth.