18
6003983_a
2.0 Configuration with berbel remote control
The procedure for configuring your extractor hood with a remote control is described in this
chapter.
Look for your model in the index.
2.1
BKH 60 - 90 EG-2,
BKH 90 GL-2
Switch on the extractor hood if you have not already done so.
Perform the steps listed below in order with the
berbel remote control
. Then your extractor hood is
ready for operation.
These settings must only be carried out during the initial commissioning.
Step
Touch field
Action
1
Press and hold the ON/OFF
button for 10 seconds.
All buttons will blink 5 times.
2
Press the recirculating air button.
The symbol now illuminates with
full brightness.
3
Press the ON/OFF button.
All buttons illuminate for 3
seconds.
4
Press and hold the ON/OFF
button for 10 seconds.
All buttons will blink 5 times.
Carry out step 5 while the
buttons are blinking.
5
Enter this button combination
during the blinking process from
step 4.
6
Press these buttons if they are
not already illuminated.
7
Press the ON/OFF button.
All buttons illuminate for 3
seconds.
Your extractor hood is now ready for operation.
