Berbel BKH 120 FO, Operating And Installation Instructions

10

Installation

6005044_0 – 04.12.2019

3.5 

Installation procedure

Short overview:
1.  Preparation for installation
2.  Unpack the device
3.  Removing the lower section, bulging edge and 

Capillar Trap

4.  Hang the device in place
5.  Connect accessories
6.  Fit the BackFlow port
7.  Install filter (with recirculating and hybrid operation)
8.  Connect exhaust air ducting (with exhausted air and 

hybrid operation)

9.  Establish electrical power supply
10. Mounting the chimney
11. Insert the Capillar Trap, bulging edge and lower section
12. Check and carry out commissioning

3.5.1 

Preparation for installation

☞

Familiarise yourself with the installation situation and the 
associated documents.

y

Device and instructions.

y

Accessories.

y

Installation location.

y

Intended operating mode.

☞

Assemble the tools and materials required:

y

Stable stepladder

y

Folding rule or measuring tape

y

Pencil

y

Spirit level

y

Slotted screwdriver SL 2.5 x 0.4

y

Torx screwdriver TX30

y

Ø 8 mm masonry bit

y

Hammer drill

y

10 mm spanner

y

Cutter blade

y

Protective material (e.g. thick cardboard) for the hob 
and the worktops

☞

Keep the installation area free of objects that could be in 
the way or that could be damaged.

☞

Make sure that the hob and other parts that could be 
touched have cooled down.

☞

Protect the hob and other surfaces in the installation area 
(e.g. with thick cardboard).

☞

Ensure that the power supply is switched off and remains 
so. Connect the power supply only when instructed to do 
so in the installation instructions.

If accessories (e.g. wall box, window contact switch) are 
required for the installation:

Observe the instructions for the accessories.

☞

Ensure that the accessories are correctly installed and 
ready for connection.

☞

Ensure that the connection cables from accessories are 
correctly routed and accessible.

3.5.2 

Unpack the device

D

ATTENTION!

Hazard of glass breaking or other damage due to 

incorrect handling!

The device and its surfaces can be damaged when being 
unpacked or transported.

☞

Do not cut into the protective cardboard packaging.

☞

Keep objects that could scratch the device far away from 
it (e.g. tools, belt buckles).

☞

Unpack the device and all accompanying parts carefully.

☞

Place the device on its back on a firm, clean and 
protective surface (e.g. thick cardboard).

☞

Check the device and its constituent parts for damage. 

☞

Check the delivery is complete. 

D

“2.4 Scope of delivery” (page 7).

If parts are missing or damaged:

☞

Please consult your dealer or customer services.

☞

Remove the packaging material.

D

“8.1 Dispose of packaging” (page 30).