Safety
8
Safety
and processes, can be found in the respective
chapters.
Ø
Read this chapter carefully before installing the
device.
Ø
Follow all the safety and danger notices during all
activities on the device.
Ø
Only install this device in private kitchens.
Ø
Make sure that the power cable is free from voltage
during installation.
Ø
Check the device and all its parts for visible
damage. In the event of damage, contact your
dealer or berbel customer service. You may only
install the device if it is in perfect working order.
Ø
Mount the device using the supplied brackets only
on load bearing building parts (solid construction).
Ø
Use appropriate fastening mechanisms for any
other sort of installation. If in doubt, please check
with the dealer. Otherwise, you endanger yourself
and others.
Ø
Always let qualified specialist personnel conduct
repair work. Otherwise, you endanger yourself and
others.
Avoiding dangers caused by electric shock
§
Only let trained, qualified electricians work on the
power supply.
The electricians must have the following knowledge
and abilities as a minimum:
§
Basic knowledge of electrical engineering
§
Knowledge of country-specific regulations
and standards (e.g. in Germany,
DIN 57100/VDE 0100, part 701)
§
Knowledge of the applicable
safety regulations
§
Knowledge of the applicable legal
regulations for gas installations (e.g.
in Germany the technical rules for gas
installations TRGI).
§
Only install the device if it is connected and fused in
accordance with the technical data.
§
Do not kink or crush the mains cable.
§
Do not use the device with a damaged electrical
connection cable.
§
In the event of a malfunction, disconnect the device
immediately from the mains.
§
The mains plug must be easily accessible so that
you can quickly and easily isolate the device from
the mains supply in the event of an emergency. If
the mains plug is inaccessible following installation,
an all-pole isolating device with a contact gap of at
least 3 mm must be installed and accessible.
§
If the device is moved from a cold environment into
a hot one, condensation may form inside the
device. In this case wait about 2 to 3 hours before
bringing the device into service.
§
Avoid exposing the device to liquids.
§
Keep the device dry.
Avoiding the risk of explosion
§
Do not install the device in an environment with a
risk of explosion.
Avoiding the risk of fire
§
Make sure that the hob has cooled down before you
cover it.
In recirculated air mode:
§
A covered or sealed ventilation outlet can cause a
fire hazard. In the case of recirculated air devices,
out flowing air must be able to escape back into the
kitchen through the ventilation slits without
impediment.
§
You may not install any objects that could impede
the airflow. Make sure that out flowing air is able to
flow into the kitchen without impediment.
Summary of Contents for BLB 60 FL
Page 63: ...Contact 63 ...