24
Operation
6004977_a – 28.02.2020
4.3
Operation of the hob
D
WARNING
Risk of burns on hot parts!
The hob, cookware and the prepared foot can become very
hot while working with the device. The heating time can be
very short with induction hobs.
☞
Avoid contact with hot parts.
☞
Monitor the device during the cooking process.
For optimum use of the hob:
☞
Make sure that the hob is clean and clear of deposits.
☞
Make sure that the base of the cookware used is clean.
☞
Lift the cookware before moving it into a different
position.
☞
Use cookware that is sufficiently large to avoid spilling
over.
☞
Do not use the hob for peeling, cutting or setting
ingredients aside.
☞
Make sure that sugar, plastic, aluminium foil and similar
materials do not come into contact with the hot hob. If
they do, remove them immediately.
☞
Observe the instructions for cleaning the hob.
D
☞
Switch the extraction on, in order to reduce the heat
development beneath the hob.
D
“4.4 Extraction operation” (page 30).
Button
Function
The device is turned off. The button
illuminates.
☞
Press the button.
y
The device switches on.
y
The buttons for the cooking zones,
extraction and menu are available for
input.
If no input takes place:
y
The device switches off after 20 seconds.
y
Other buttons or indicators go out.
The cooking zone is selected with the
corresponding button or via the automatic
pot recognition.
☞
Press the button.
y
The button illuminates brightly.
y
The slider, the power button and the
simmer button illuminate briefly.
y
Further entries only apply for the selected
cooking zone.
Button
Function
☞
Choose a power level by tapping or
swiping the slider.
y
The selected power level is displayed.
y
The cooking zone is heated accordingly.
y
The automatic extraction starts with the
appropriate setting.
D
“4.4.2 Run-on function” (page 31).
☞
Press the button to start the power stage
(“booster”).
y
The selected power level is displayed.
y
The cooking zone is heated accordingly.
y
The output of the automatic extraction is
adapted with a corresponding setting.
y
If the power stage is switched on in all
cooking zones at the same time, automatic
adjustment to lower power levels takes
place.
By pressing the button, the setting takes place
in the sequence:
Booster –> Double booster –> Power level 9
–> Booster, etc.
☞
Press the button to start the simmering.
y
The selected power level is displayed.
y
The cooking zone is heated accordingly.
y
The output of the automatic extraction is
adapted with a corresponding setting.
By pressing the button, the setting takes place
in the sequence:
Simmer at 42 °C –> Simmer at 70 °C –>
Simmer at 94 °C –> Power level 0 –>
Simmer at 42 °C, etc.
Additional functions are available via the
menu button.
☞
Press the menu button.
y
The symbols of the functions are displayed.
D
The functions are described in the
respective sections.
☞
Press the button.
y
The device switches off.
y
The run-on function starts with the
appropriate setting. The run-on function is
stopped by pressing the button again.
After the cooking process is finished, the device must always
be switched off.
The functions described below are available when the device
is switched on.
Summary of Contents for Downline BKF 83 DL-A
Page 40: ...6004977_a 28 02 2020 ...
